The study of wood as a renewable material and organic material is what is known as wood science. In other words, the term wood science can also be known as wood technology. Other products are put alongside wood for easy testing and study. Materials properties, ease of it being worked on and its value are among the few properties which are compared against those of wood and other materials. Wood has many advantages and this technology takes the advantages and utilizes them. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. Once a tree has been cut down another can be planted in the same spot. All the parts of wood can be put into use, and this makes it a better fit than other materials which most of their byproducts are a waste.
For your wooden products and house to stay for long and have a good appearance it needs to be protected. The biggest threat to wood being moisture and insects has to be kept away from the wood. The water particles in the timber increase the rotting and the insects bore through the wood. Many methods are available in the treatment of wood one of the most common being the ACQ – alkaline copper Quaternary. As the name implies the preservative is made of copper products. Although being a good method to use for wood protection it has presents some few challenges. The chemical is highly corrosive to most metals, the chemical corrodes away galvanized fasteners and therefore only stainless steel is used. The species of the wood and the application of the wood will determine how many chemicals will be used on the wood. The level of chemical concentration will be determined by where the piece of wood is going to be put to use.
Many methods are being invented to protect the wood, and one of them is the copper metal method. This method is being accepted fast because is friendly to wooden fasteners. This process is what in other words called the micronized copper wood preservative. In this process microscopic particles of solid copper metal are mixed in a liquid carrier and injected to the wood at high pressure. The difference between this method and the other copper-based methods is that the copper is used as a metal rather than a dissolved material. When this process is used to treat timber the timber properties are increased highly. The wood products protected using this method last longer.
Termites cannot eat through timber treated through this method. It has also shown to be an improvement in corrosion resistant properties to metal fasteners. When you use this method to treat wood, then you will not need to worry for at least ten years.
Suggested Post: these details